Parking Block Installation

Solid Plastic Parking Block Installation Instructions

Lag Bolt Method: Recommended for Asphalt or Concrete Traffic Lanes where Drilling Holes is permitted

Required:

1. position the Parking Block in its installation position and, using its pre-drilled holes as templates, mark the location of each hole on the roadways surface

2. Remove the Parking Block. Using a high-speed hammer drill with a 3/4" masonry bit, drill a hole at each marked location to a depth of 3-1/2" below the parking surface

3. Insert a lag anchor into each hole (large anchor opening on top) Tap the anchor into the holes with a hammer so that the anchors are set flush with the surface. Place a washer over each anchor hole

4. Make sure the substrate is thoroughly clean and dry. Reposition the Parking Block in it's installation position. Apply firm hand pressure. Slip a washer onto a lag bolt, insert the bolt through a pre-drilled hole in the Parking Block and tighten the bolt about three quarters of the way with a 3/4" socket. Repeat for each hole in the Parking Block. Finish tightening each bolt until just snug. DO NOT OVERTIGHTEN! Excessive tightening may damage the Parking Block and void the product warranty.

Solid Plastic Parking Block Installation Instructions

Steel Spike Method: Recommended for Asphalt or Wood Block surfaces only

Required:

1. position the Parking Block in its installation position and, using its pre-drilled holes as templates, mark the location of each hole on the roadways surface

2. Remove the Parking Block. Using a high-speed hammer drill with a 3/8" masonry bit, drill a hole through the roadway surface at each marked location to avoid fracturing the asphalt with the spike

3. Make sure the substrate is thoroughly clean and dry. Reposition the Parking Block in it's installation position. Drive the spike through the Parking Block and into the drilled hole until the spike is snug against the counter gored surface of the Parking Block pre-drilled hole. DO NOT DRIVE BEYOND "SNUG"! if driveb to far, spikes may damage the Parking Block and void the product warranty.

Speed Bump Main Menu / Parking Block Main Menu


Product List
Site Map
Quotations
Shipping
Terms

New Century NORTHWEST LLC
775 Vincent Street
Eugene, Oregon 97401
Phone: (541) 342-4500 Fax: (541) 485-5566
E-MAIL sales@ncnwest.com HOME PAGE