Decking Fasteners - Stainless Steel or Ceramic Coated Screws (#9 or larger) are recommended. 2 per end of board and alternate 1 in middle.


Zinc plated crews are NOT recommended because of the inconsistent quality of these screws and could jeopardize the warranty.

Pre drilling with a hole over the board to the next screw size (1/4" drill bit for #10 screws) will get the best results.

All Fasteners should be placed no closer than 3/4" from any edge and not at an angle of more than 20 degrees.

The use of adhesives is not recommended. The maximum length for fascia is 8'